The improvements of the ASCU2 gen.5 are:
New MOSFET module with a 6 times smaller resistance - it results in a faster firing cycle, higher efficiency of the active brake, higher amount of shots per battery charge and a smaller amount of generated heat
New, stronger trigger connector
New, reinforced design, entirely covered with polymer
Easier installation
Software update with an easier programming system
Improved cutoff lever and selector plate
ASCU is a two-piece electronic module (consisting of a command unit and a sensor unit), which, once installed in airsoft replicas, significantly improves their operation
Control de motor with a active brake Mosfet
The ASCU will stop the piston in the incial position, after every shot, in semi and full auto mode
is capable of completing full cycles of the gearbox operation, that's why a BB will never remain in the barrel and the spring will never be strained
features a Low Drain Protection system specially designed to protect lithium-ion batteries (LiPo) from damage
stops the replica's firing cycle in case of any problems, this will protect the internal elements from further damage
The unit gives a faster trigger response in an AEG replica
It prevents accidental, double shots
Easy-to-install in any V2 gearbox
controls the charge level of a battery and does not allow its over-discharge
Easy programming of fire modes in following configurations:
Safe + Semi + 3 Rnd Burst + Full Auto
Safe + Semi + Full Auto
Safe + Semi + 3 Rnd Burst
Safe + Semi Only
3 years garanty mounted in a specialized center